# Fitting to specific curves

## Fitting to a line

This command is used to fit a curve which has a linear shape.

Figure 6-4. The results of a Fit Linear (Default). The results will be given in the Log panel: ## Fitting to a polynomial

This command is used to fit a polynomial function to data which has a curvilinear shape. It opens the Polynomial Fit Options dialog, allowing you to choose the curve to fit, the order of the polynomial function to use, the number of points of the resulting curve and the abscissa limits for the fit.

The results of the fit are displayed in the Log panel.

Figure 6-5. The results of Fit Polynomial.... ## Fitting to a Boltzmann function

This command is used to fit a curve which has a sigmoidal shape. The function used is:

Equation 6-3. Boltzmann equation in which A1 is the low Y limit, A2 is the high Y limit, x0 is the inflexion (half amplitude) point and dx is the width.

Figure 6-6. The results of Fit Boltzmann (sigmoidal). ## Fitting to a Logistic function

This command can be used to fit a curve which has a sigmoidal shape. The function used is:

Equation 6-4. Logistic dose response equation where A1 is the initial Y value, A2 is the final Y value, x0 is the inflexion point (center) and p is the power.

Figure 6-7. The results of Fit Logistic compared to Fit Boltzmann (sigmoidal). ## Fitting to a Gauss function

This command is used to fit a curve which has a bell shape. The function used is:

Equation 6-5. Gauss equation in which A is the height, w is the width, xc is the center and y0 is the Y-values offset.

Figure 6-8. The results of Fit Gaussian. ## Fitting to a Lorentz function

This command is used to fit a curve which has a bell shape. The function used is:

Equation 6-6. Lorentz equation in which A is the area, w is the width, xc is the center and y0 is the Y-values offset.

Figure 6-9. The results of Fit Lorentzian. ## Fitting to a PsdVoigt1 function

This command is used to fit a curve with a Pseudo-Voigt function which is a linear combination of Gaussian and Lorentzian functions:

Equation 6-7. PsdVoigt1 equation The parameters of the PsdVoigt1 function have the following meaning: y0 is the Y-values offset, A is the area, w is the width (FWHM), xc is the center and mu is a profile shape factor.

## Fitting to a PsdVoigt2 function

This command is used to fit a curve with a Pseudo-Voigt function which is a linear combination of Gaussian and Lorentzian functions with different FWHM:

Equation 6-8. PsdVoigt2 equation The parameters of the PsdVoigt2 function have the following meaning: y0 is the Y-values offset, A is the area, wG is the Gaussian FWHM, wL is the Lorentzian FWHM, xc is the center and mu is a profile shape factor.

Figure 6-10. The results of Fit Pseudo-Voigt -> PsdVoigt2.... 